Home Subscription Services
 
   

 
The Journal of Adhesive Dentistry
JAD Home Page
About the Editor
Editorial Board
Submit
Author Guidelines
Submission Form
Reprints / Articles
Permissions
Advertising
Advertising
MEDLINE Search
 
 
 
 
 
FacebookTwitter
Quintessence Publishing: Journals: JAD

 

The Journal of Adhesive Dentistry

Edited by Jean-François Roulet

ISSN (print) 1461-5185 • ISSN (online) 1757-9988

Publication:

Summer 2001
Volume 3 , Issue 2



Back
Share Abstract:

Microtensile Bond Strength Single-step Adhesive Bur-prepared Dentin

Inoue, Hiroshi; Inoue, Satoshi; Uno, Shigeru; Takahashi, Akiko; Koase, Kaori; Sano, Hidehiko

Purpose: To compare the microtensile bond strength (MTBS) of two single-step adhesive systems to two types of bur-prepared dentin. Materials and Methods: Using either of two adhesives, the experimental MZ-2000 (MZ) and the commercial One-Up Bond F (OUB), resin composite was bonded to flat buccal and root dentin surfaces of eight extracted human premolars. These surfaces were produced by grinding with either regular-grit or superfine-grit diamond burs in a high-speed handpiece. After storage overnight in 37C water, the bonded specimens were sectioned into ten slices approximately 0.7 mm thick, perpendicular to the bonded surface. They were then subjected to microtensile testing. The surfaces of the fractured specimens were observed both visually and microscopically to determine the failure mode. In addition, to observe the effect of conditioning, the two types of bur-ground dentin surfaces were conditioned with the adhesives, rinsed with acetone, and observed under SEM. Results: When MZ was bonded to dentin prepared with a regular-grit diamond bur, MTBS was the lowest and failures occurred adhesively at the interface, whereas other groups revealed primarily mixed failures. MZ-conditioned dentin surfaces ground with a regular-grit diamond bur were covered with a residual smear layer. However, the smear layers on the surface of MZ-conditioned dentin ground with a superfine-grit diamond bur and on OUB-conditioned dentin prepared either with a regular-grit or superfine-grit diamond bur were mostly or partially dissolved. Conclusion: Some of the single-step adhesive systems may produce low bond strengths to smear layers created by regular-grit diamond burs.

Full Text PDF File | Order Article

 

 
  © 2014 Quintessence Publishing Co Inc
 

Home | Subscription Services | Books | Journals | Multimedia | Events | Blog
Terms of Use | Privacy Policy | About Us | Contact Us | Advertising | Help | Sitemap | Catalog