Home Subscription Services
 
   

 
The Journal of Adhesive Dentistry
JAD Home Page
About the Editor
Editorial Board
Submit
Author Guidelines
Submission Form
Reprints / Articles
Permissions
Advertising
Advertising
MEDLINE Search
 
 
 
 
 
FacebookTwitterYouTube
Quintessence Publishing: Journals: JAD

 

The Journal of Adhesive Dentistry

Edited by Jean-François Roulet

ISSN (print) 1461-5185 • ISSN (online) 1757-9988

Publication:

Winter 2003
Volume 5 , Issue 4



Pages: 267-282
Back
Share Abstract:

Factors Contributing to the Incompatibility Between Simplified-step Adhesives and Chemically-cured or Dual-cured Composites. Part. III. Effect of Acidic Resin Monomers

Suh, B. I./Feng, L./Pashley, D.H./Tay, F. R.

This study examined the polymerization kinetics of acid-contaminated light- and chemically-cured resins with the use of differential scanning calorimetry. Light-cured and chemically-cured versions of an experimental bis-GMA/TEG- DMA resin at the ratio (w:w) of 62:38 were prepared. Four acidic resin monomers with either carboxylic (DSDM and MAA) or phosphoric functional groups (MP and 2MP) were added at a 10 wt% concentration to these resins to simulate the intermixing of resin composites and unpolymerized acidic monomers along the adhesive-composite interface of simplified-step dentin adhesives. Different concentrations of the most acidic monomer 2MP (10 to 50 wt% for the light-cured resin, and 2 to 4 wt% for the chemically-cured resin) were also added to examine their contribution to reducing the extent and rate of polymerization of these resin mixtures. The effect of sodium benzene sulphinate on the polymerization of the chemically-cured resin that was contaminated with 10 wt% 2MP was also investigated. At 10 wt% concentration, all acidic monomers had a limited effect on the polymerization of the light-cured resin. The rate and extent of polymerization in the chemically-cured resin was substantially reduced by the carboxylic acid monomers DSDM and MAA, while polymerization was completely inhibited in the presence of the organophosphate monomers MP and 2MP. Substantial reductions in the rate and extent of polymerization of the light-cured resin occurred only in the presence of high concentrations (30 to 50 wt%) of 2MP. More acute polymerization inhibition was observed when the chemically-cured resin was contaminated with 2 to 3 wt% 2MP, with polymerization completely inhibited at 4 wt%. Addition of sodium benzene sulphinate to 2MP-contaminated chemically-cured resin revived the previously uncured resins, but their rate and extent of polymerization were still inferior to that of uncontaminated chemically-cured resin. When the influence of adhesive permeability was excluded with the use of neat, water-free resins, deactivation of the tertiary amine utilized in the chemically-cured resin by even very low concentrations of acidic resin monomers accounts for the reported incompatibility between simplified-step dentin adhesives and chemically-cured composites. The polymerization of light-cured resin is only affected by much higher concentrations of acidic resin monomers.

Full Text PDF File | Order Article

 

 
  © 2014 Quintessence Publishing Co Inc
 

Home | Subscription Services | Books | Journals | Multimedia | Events | Blog
Terms of Use | Privacy Policy | About Us | Contact Us | Advertising | Help | Sitemap | Catalog