Home Subscription Services
 
   

 
The International Journal of Prosthodontics
IJP Home Page
About the Editor
Editorial Board
Accepted Manuscripts
Submit
Author Guidelines
Submission Form
Reprints / Articles
Permissions
Advertising
MEDLINE Search
 
 
 
 
 
FacebookTwitterYouTube
Quintessence Publishing: Journals: IJP
The International Journal of Prosthodontics

Edited by George A. Zarb, BChD, DDS, MS, MS, FRCD(C)

ISSN 0893-2174

Publication:
January/February 2009
Volume 22 , Issue 1

Back
Share Abstract:

Effect of Proximal Wall Height on All-Ceramic Crown Core Stress Distribution: A Finite Element Analysis Study

Paulo G. Coelho, DDS, PhD/Nelson R. Silva, DDS, PhD/Van P. Thompson, DDS, PhD/E. Dianne Rekow, DDS, PhD/Guangming Zhang, PhD

Pages: 7886
PMID: 19260434

Purpose: Mechanical analyses of idealized crown-cement-tooth systems through finite element analysis (FEA) has provided valuable insight concerning design parameters and materials that favor lower stress patterns. However, little information regarding variation of basic preparation guidelines in stress distribution has been available. The primary objective of this study was to evaluate maximum principal stresses on a molar crown veneer plus core system natural tooth configuration preparation with variations in the ratio of proximal axial length (PAL) to buccal axial length (BAL) as well as loading condition and position. Materials and Methods: Three-dimensional models comprising a crown veneer (porcelain), crown core (zirconia), cement layer, and tooth preparation (4.2 mm BAL with PAL reductions of 0.8 mm, 1.0 mm, and 1.2 mm) yielding BAL:PAL ratios of 1.23, 1.31, and 1.4 were designed by computer software (Pro/Engineering). The models were imported into an FEA software (Pro/Mechanica), with all degrees of freedom constrained at the root surface of the tooth preparation. Each tooth preparation crown configuration was evaluated under a vertical (axial) 200 N load, and under a combined vertical 200 N and horizontal (buccally) 100 N load applied at different positions from the central fossa to the cusp tip. Maximum principal stress (MPS) was determined for the crown core for each crown BAL:PAL ratio, loading condition, and position. Results: Under both vertical and combined loading conditions, the highest MPSs were located at the occlusal region and in the occlusogingival region of the ceramic core. MPS values increased in the proximal region as the BAL:PAL ratio increased. Combined loading resulted in a general increase in MPS compared to vertical loading. Conclusion: Increasing the BAL:PAL ratio (reducing the proximal axial length of the preparation) acted as a stress concentrator at regions near the crown margins, suggesting this area may be vulnerable to damage from fit adjustment as well as during function. Such increases in stress concentration should be considered in clinical scenarios, especially when inherent flaws are present in the material, since extensive high-magnitude tensile stress fields have been noted under all loading conditions.Int J Prosthodont 2009;22:7886.

Full Text PDF File | Order Article

 

 
Get Adobe Reader
Adobe Acrobat Reader is required to view PDF files. This is a free program available from the Adobe web site.
Follow the download directions on the Adobe web site to get your copy of Adobe Acrobat Reader.
  © 2014 Quintessence Publishing Co Inc
 

Home | Subscription Services | Books | Journals | Multimedia | Events | Blog
Terms of Use | Privacy Policy | About Us | Contact Us | Advertising | Help | Sitemap | Catalog